Frequently Asked Questions
How does fitment work?
Every kit is cut for a specific vehicle. On the product page you give us your Year, Make, and Model, and the pattern for your exact vehicle is precision-cut — including the right facelift, trim, and sensor cutouts once we verify your photos.
Do I need to give you my VIN?
No — VIN is optional. Year/Make/Model is required. If you do add your VIN, it helps us confirm your exact trim and facelift before we cut, which is especially useful on mid-year changes. Recommended, never required.
Why do you ask for verification photos?
Because two vehicles with the same year and model can have different front ends or windshield sensors. For PPF we ask for a straight-on front photo, a 3/4 angle, and a close-up of the bumper and headlights. For windshield tint we ask for an inside photo of the mirror and sensor area and an outside photo of the windshield. Uploading them on the product page is optional — it just speeds up your order. If you don't have photos handy, order anyway and we'll reach out after your order to get them. Either way, we check them before cutting so your kit fits the first time.
What does the Lifetime Warranty cover?
Film defects, for as long as you own the vehicle: delamination, fading, yellowing or discoloration (including tint turning purple), cracking, bubbling from adhesive failure, and loss of clarity. It does not cover lifting or peeling from un-heated edges, rock damage, accidents, or install errors. Full terms are on our Lifetime Warranty page.
Is DIY install hard?
It is very doable with patience. Every piece comes weeded and labeled, and our Install Guide walks you through the slip and tack solutions and every step. Two honest warnings: our PPF film is high-tack, so it grabs fast — use plenty of slip solution and work in sections. And post-heat every edge when you finish; that is the step that keeps edges down for good.
Is window tint legal where I live?
Tint laws vary by state and cover things like how dark each window can be. Checking and following your local tint laws is the buyer's responsibility. We will happily cut any shade we offer — what is legal on your vehicle where you drive it is up to you to confirm.
What comes in the box?
Your precision-cut, weeded, and labeled film pieces, rolled in a protective box — never folded — plus the printed instruction card. Kits are film only: you will need your own squeegee, microfiber towel, two spray bottles, and a heat gun or hair dryer. The full list is on our Install Guide page.
Can I pick my kit up instead of shipping?
Yes — local pickup is at 10750 Irma Drive, Unit 5, Northglenn, CO 80233. Order by 12pm MT with your verification photos in and it is ready the same day. Wait for the ready-for-pickup email before heading over.
How do I contact you?
Email us at support@purefilmkits.com and we'll get back to you as soon as we can.