Before You Start
Important: Pure Film Kits kits are film only — precision-cut, weeded, and labeled film pieces. No install kit or supplies are included in the box. Everything below is what you need to have on hand yourself.
What you need
- A squeegee
- A microfiber towel
- Two spray bottles — one for slip solution, one for tack solution
- A heat gun or hair dryer — for post-heating edges (do not skip this step)
- 99% isopropyl alcohol, Johnson & Johnson baby shampoo or Seventh Generation soap, and clean water
Mix your solutions
Slip solution: 32oz of water + a couple drops of Johnson & Johnson baby shampoo or Seventh Generation. No more than a couple of drops — too much soap fights the adhesive.
Tack solution: 30oz of water + 2oz of 99% isopropyl alcohol, in a 32oz spray bottle. Tack is recommended on edges and corners — it locks the film down so it does not lift back, especially if your squeegee technique is not perfect yet.
Install steps
- Prep and clean — wash the panel or glass thoroughly. Any dirt left behind ends up under the film.
- Slip to position — wet the surface and the film with slip solution, lay the labeled piece in place, and slide it into its exact position.
- Work in sections — squeegee from the center out, one section at a time. Do not try to lay a whole panel at once.
- High-tack warning (PPF) — our PPF film has an aggressive, high-tack adhesive. It grabs fast and edges stay down — but it is less forgiving. Use plenty of slip solution and commit to each section as you go.
- Tack the edges — spray tack solution on edges and corners and squeegee them down to lock them.
- Post-heat ALL edges — run your heat gun or hair dryer along every edge to seal it. Lifting edges almost always trace back to skipping this step, and lifting from un-heated edges is not covered by the warranty.
Every piece in your kit is labeled, so you always know which pattern goes where. Take your time — a patient install is a clean install.